-
Very unsatisfied
-
1
-
2
-
3
-
4
-
5
-
Very satisfied
I am needing to laminate my print from a Latex 335 (Print & Cut Solution) and having issues with contour cuts not being deep enough to weed after laminating. I tried this previously by laminating after printing and before cutting. Everything went fine, but when cutting after laminating the cuts weren't deep enough to weed. I am sure I can make these deeper by adjusting the knife in the cutter and/or through the menu of the cutter, but is there an easier way/method? I am newer to this, so any advice is appreciated.