115 P&C - Cut moves in orizontal side(only on the right)

Using HP Latex 115 P&C with 137 cm vinyl media (calibrated with low temperature 10 passes and using straightness optimizes) i don't have deformation. After positioning media under HP Summa cutter, the cut moves 2 mm only in right side (left side and center are almost precise). Issue is on X Assy. Any suggestion?

Hi @TecnicoFontanarosa, If the contour does not match the printed design, check the following items: • Check for media transport. • The shift calibration determining the offset between the knife tip and the OPOS sensor may be off. Run the OPOS offset calibration test. [MENU] – [SYSTEM SETUP] – [CALIBRATIONS] – [CAL. OPOS]. • The sensitivity of the OPOS sensor may not be set correct for the media used. Check OPOS sensitivity setting. [MENU] – [SYSTEM SETUP] – [CALIBRATIONS] – [CAL. MEDIA]. If the issue still happening after this recommendation, please get in touch with HP support.

I am having similar issues, cutting just off to the left on the x axis. I tried both solutions above, issue persists.