3 layer print

I am having difficulty printing a 3 layer print on panagraphic banner material. The base layer starts out looking really smooth then about 4 feet into the print, the base layer starts to look streaky. Which affects the illumination. Any suggestions ?

Hi @banner.112292,

Can you please advise what printer are you using and provide a picture illustrating the issue?

HP R2000

The base layer is banned

Hi @banner.112292,

There are several root causes for the issue you are facing. Here is some advice on how to fix it:

• Are you using the Edge Holder correctly? Check if they are rubbing the printheads, as this would be very harmful to the printheads' health.

• Perform a nozzle health check plot and revise the status of the printheads, maintaining focus on the black ink and optimizer fluid printhead, in order to replace them.

• Is the cleaning station working properly? Check if the cleaning roll has wrinkles and if it is colliding with the printheads; if that happens, please get in touch with your support representative.

If none of these is working, please contact your support representative for a more thorough investigation.