Heat transfer vinyl material sticky and smearing while curing

Hello, I'm using a Printer: HP Latex 360 Material: 15" Siser Easyweed Heat Transfer Vinyl Profile: Siser Easy Transfer Color: CMYK I'm trying to print a design to test the heat transfer to tshirts process. I'm having an issue during the curing process on the print. The design prints beautifully, however as it comes out of the curing process, the ink is smeared. At one point, the material became sticky, sticking to the printer and I had to pull the material through the rest of the print to avoid head strikes. Attached is the picture I took of the final product. It's very disappointing as the material was very expensive. I've had an issue with the smearing on banner and vinyl too, not sure what it is that's causing this. I assume it's a heat issue (curing at 240), where the heat is too high as it's curing because not only is the ink smearing as it's coming out, but the material is sticky. Please advise.

Hi, Advancing your media to the take up reel should work but we all know that media is expensive and don't like wasting the 4 feet it takes to hook up to the TUR. Try installing the Output Platen covers. It should help the material travel through the curing section better, also lower the temperature. I have found that most profiles are preset way too hot. Good Luck Roy K