HP DesignJet L26500 (HP260 Latex) blues printing purple

I have recently noticed that my EPS files I have been printing containing PMS colors that are blue in nature are printing on the purple-ish side. I have printed out all the test, printhead and color plots and they look perfect. This has happened on both a banner material profile and wet-strength paper profile, both of which 'used' to print normally. I cannot pin-point where the issue is... profiles, inks, printheads or the Adobe Creative Suite ink management? Below is some of the current information on the inks/printheads in the machine. Ink: M Cartridge: 766ml - exp. 3/13/18 Y Cartridge: 497ml - exp. 6/2/15 K Cartridge: 761ml - exp. 3/15/19 C Cartridge: 760ml - exp. 3/11/19 LM Cartridge: 473ml - exp. 6/30/14 LC Cartridge: 704ml - exp. 5/13/14 Printheads: C-LC PH 1: fired: 100ml (2016) C-LC PH 2: fired: 121ml (2015) Y-K PH 3: fired: 1478ml (2011) Y-K PH 4: fired: 35ml (2016) M-LM PH 5: fired: 30ml (2016) M-LM PH 6: fired: 31ml (2016) Color Correction: checked off The attached JPEG shows the Pantone 300c chip overlaying the actual print which looks very much like periwinkle. Thanks, Jim

Attachments

   IMG_0003.JPG

In opposite to Dye-Ink, I would not use pigmented ink for a long time after they expire. The pigments could settle in the cartridge, so the printer could print with a much lower pigment density in the ink than with a new cartridge. You should switch on color management too. While for example C100/M100 should give blue, most of the outdoor inks prints that ink relation very purple.

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel

I have experienced incorrect colours with both Latex and other HP printers. Have seen that the internal test prints for the PH's look perfectly fine so I start trying everything to correct but ultimately come back to replacing a PrintHead or two to correct the issue. I noticed that you have one YK PH dated 2011 (#3) with over 1000 ml ink used . I would start by replacing this printhead. It is 4-5 years older than the others. I would also start thinking about replacing 2 PH's at a time. When you replace one of a colour, replace both. You will see more consistency with your colours when you try to keep the usage of matching colours as equal as possible and you will likely get 2 from the same production lot. Good Luck Roy K

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel

I thought that was probably going to be an answer but in the effort to save $$$ for the company, I was hoping to find another work around. Penny wise, pound foolish!

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel