What was your overall satisfaction with LKC?
-
Very unsatisfied
-
1
-
2
-
3
-
4
-
5
-
Very satisfied
Hi Guys, Hope you can help or offer some advice please A couple of times today, and once during the week, we had the print almost swerve off its path Our prints have an equal gutter on each side of the print The roll remains straight, it is not unwound uneven, but for some reason the print seems to be drifting off course Almost in steps like a small swerve, before resuming a straighht line on a new path and then the same again If you see the attached images The result, was that what was a 2cm gutter on each side, had become almost 4cm on one side, and 0.5cm on the other side, after several metres of printing Any suggestions what may be causing this ? Its only on one of our 5 machines Ive tried to show it in a diagram, and also a couple of shots that show how it swerves and drifts Any help greatly appreciated thanks a lot Jack