Latex 560 - Head crash printing to Dreamscape DS-TERRALON sd -13-54-50 wall covering

HP Latex 500 Series

#1 Thinklittle 7 years ago

I have been fighting with head crash on our new HP Latex 560 for several days now while printing on Dreamscape Terralon PN S-TERRALON sd -13-54-50 wall covering. The profile that we are using was obtained from HP download via the printer control screen. We are using Onyx v12. I am using a take up roll and have ensured that the skew was within acceptable limits per the printer. I have tried: 1. lifting the print rollers and repositioning the substrate. 2. completly unloading and re-loading media ensuring everthing was nice and flat. 3. Utilize the edge guides with no luck. I am new to this printer and Rip software so I am at a loss to know where to adjust the curring temp, and or vacume setting for a perticular job. Can you pont me in the right direction regarding adjusting these settings on this printer? Thank you.

#2 Thinklittle 7 years ago

Thank you for the input. I wound up being a curing tempreture issue. The curing temp in the profile was set to 221F and as the substrate entered the curing area it was shrinking and that caused waves in the substrate. The waves were just high enough for the print head to make contact. I reduced the curing temp by 10F and the issue was resolved. The Latex 560 has two optimizers so the ink cures just fine at the lower temp.

Was this helpful?