Latex 570 - Printheads carriage hits Maintenance cartridge

HP Latex 500 Series

#1 ivoslbg5445 5 years ago

Hi all. When starting prints the Maintenance cartridge (MC) is moving when printhead carriage is going back to the right (over the MC position) and printheads hits highest point of the MC cloth causing damages to the first row of printheas. It happens randomly, it is not before every print, sometimes happens once a week, sometimes - once a day, sometimes -in 2 prints one after another and nothing after that... The same happened on the previous Latex 360 printer, but the technicians have no clue of what's causing this. I apply some photos. Best regards and cheers

Attachments

IMG_20190607_011.jpg

IMG_20190607_101833.jpg

#2 ivoslbg5445 5 years ago

#2 Hi It happens with brand new and used MC's and everything is clean around and under the cartridge. I suspect it's wrong commanding from board but don't want just play with guessing Thanks again and best regards.

Was this helpful?

Yes0

No0

How can we improve it?

#3 ivoslbg5445 5 years ago

Good news (fingers crossed) last week tech minions replaced the SSD (after opening a case with HP support - guessing bad or broken firmware). So far - normal printing

Was this helpful?

Yes0

No0

How can we improve it?