Cancel search

L28500 Error Message

HP Latex 200 Series

#1 POSvisual 6 years ago

Hi there, our L28500 has an error message appearing on the LCD screen - 14.63:11
Our local Reseller has advised that the error is related to a "Dryer Module" issue and that the replacement part will cos AUS $9000 Inc labour!
Obviously we are not happy about this and therefore I wanted to see if anyone else has experienced this problem and had a much cheaper fix solution??

#2 paulelw 4 years ago

#1 Worst case you would definitely need the new part and a technician to install.

Other causes of this error are:

Room temp is too high - check for surrounding heat sources.

'Minimum Drying power' setting in the RIP is too high it can trigger the error. Set minimum drying power to 0 and check if error remains.

Check for any obstructions on any cooling fans.

Check that all fans are functioning properly. The fans can be checked and replaced by a technician. This would cost a lot less than the entire new part.

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex


HP Latex Blog


How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.