Banding

HP Latex 300 Series

#1 HP-MarcM 8 years ago

Hello Experience49, Hope you are doing good. Please, could you give us more information about this issue? Thanks a lot, Best,

#2 Experience49 8 years ago

Thanks for getting back with me, The vertical Banding issue we are having is mostly when printing on Abaco Beach wallpaper, and the vertical bands seem to be happening in the areas between the surface rollers and the airflow diffusion vents. Would be great if we were able to control the airflow pressure below 175. Currently locked out from adjusting below 175, When we first had this printer we could make adjustments to this as low as 50 to 75 area. Please advise if you have any other thoughts.

Was this helpful?

Yes0

No0

How can we improve it?

#3 HP-MarcM 8 years ago

Hi Experience49. As long as I know, the airflow pressure can't be lowered below 175 due to security reasons. I would recommend you to contact your support source in order to properly address your vertical banding issue. please let me know the solutions once you solve your issue.

Was this helpful?

Yes0

No0

How can we improve it?

#4 HP-MarcM 8 years ago

Hi Experience49, I was wondering, have you been able to contact with technical support? If yes, they can give you a properly answer to this issue? Please, let me know. Have a good day.

Was this helpful?

Yes0

No0

How can we improve it?

#5 TradeLabelSoftware 2 years ago

Adjust your printer heaters according to use to dry printing and keep media in better condition. You need to readjust the position of the print head in the carriage.

Was this helpful?

Yes0

No0

How can we improve it?