Cancel search

Dust sticks to wet latex imprint

HP Latex 300 Series

#1 --- 7 years ago

Hello,

I have problem with my latex printer,

when i print imprints that needs more ink (like backlight foil 16p230%)

Some dust stick to the wet surface before drying chamber.

After printing when everything is dry you can remove this dust/powder but you have white spots (like ones from photos I attached)

Attachments
   DSC_1067.jpg
   DSC_1069.jpg
#2 HP-Sonia 7 years ago

Hello @Maciej

After looking at your images I can suggest to:

  • Check the surface of the material? Try to keep the rolls in a clean, upright position and inside a bag.
  • Check if there is dust in the place or above the printer, it could enter the printing area and cause the issue that you are explaining.

If you continue to experience the white spots in your prints. Let your support team look at it. From time to time you have to perform a service maintenance where different internal areas of the printer (curator, platen, etc.) are cleaned and some parts are replaced in case they need.

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

New comments are not available at this time

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.