Cancel search#1 Yeah, once it's stuck in setup mode and throwing 25.11.10 and 75 errors, it's usually firmware-locked. Swapping the ISS board and EEPROM can mess with region or tank config. You might need service mode access or official tools to reset it hard to bypass otherwise.
Yes0
No0
#2 I was able to get past it all by getting some new bulk ink tanks and a couple of new cartridges. I believe it was trying to purge the bulk ink lines automatically, but some of the cartridges were already full so it was trying ro force more ink in. Luckily I think it didn't do any damage. But it's working now...
Yes0
No0
Remember
To make recommendations or participate please Sign In and post a message.
Loading...
Loading...
I had a iss board go bad and I tried a eeprom to try and recover it, but now the printer is stuck in setup mode. At first it wouldn't accept the large ink tanks, so I had to buy a couple of new ones. Now it will throw an 25.11.10 error with the normal ink cartridges uninstalled, even with the ink cartridges installed it tries to do something, but then throws a generic 75 error and I have to restart. Is there anyway to skip all this?