What was your overall satisfaction with LKC?
-
Very unsatisfied
-
1
-
2
-
3
-
4
-
5
-
Very satisfied
Hello All, I'm fairly new to troubleshooting Latex printers and need a little help reading the print tests: We had banding in a few of our larger prints, which I had chalked up to an ink and the optimizer running out in the middle of printing. 3 more inks were nearing replacement so we swapped those out after running a test print. We also ran an automatic head alignment and head cleaning. The attached prints are the tests from the alignment and after the cleaning. There is still some light banding, but passible for this project. I can't tell if there is anything particularly striking about these prints that indicates further fixing or possible parts replacements at this point. Thank you in advance! EDIT Never mind, got through two 12ft prints and now the banding is back on the 3rd. Will upload picture once I figure out how