Pre cut sheets

Can the HP Latex 115 print on pre cut sheets without being wound on the roller

Hi @steve10272,

The printer is designed to be used with rolls of substrate. It is possible to load cut sheets into the printer, but the print quality cannot be guaranteed, and you may have some difficulty in avoiding skew.

• The sheet should be at least 1067 mm (42 in) long.

• Load the sheet by following the normal roll loading procedure (automatic or manual, depending on the substrate).

• During the loading procedure, the printer tries to detect the winding direction of the roll by turning the spindle in both directions. When the substrate is not attached to the spindle, the following message appears in the front panel: Roll direction not detected, ensure the substrate is tight on the roll, and retry.

• A cut sheet is likely to be loaded with excessive skew, and the printer may not be able to correct it automatically. If the skew as measured by the printer exceeds 3 mm/m, you are recommended to reload the sheet. However, if the skew ist tolerable, you can consider skipping the automatic skew correction. To do so, when prompted, choose to Continue with the current skew.