Cancel search

print problem

#1 tez069176 a month ago

Hi,i added a new print mode recently and I have noticed the right hand edge of some prints (not all) seem to have a bit of extra bleed (correct me if i am wrong) before i was using an icc profile that fitted my media the closest 8p CMYKcm 90 curing temp 70(preset) and all prints well, since i added a new print mode and printed the colour saturation and ink drying test (not sure how to use this as of yet) with settings 6p CMYKcm 90 curing temp 60 i seem to have this problem, i have tried increasing the curing temp to 70 on the fly but made no difference. any help/suggestions appreciated. Regards.

Attachments
The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Latex Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.