What was your overall satisfaction with LKC?
-
Very unsatisfied
-
1
-
2
-
3
-
4
-
5
-
Very satisfied
Hi all, I am using a 1370mm wide media on the 335 for a print & cut job using SAi My artowrk is 180mm w x 295mm h and my issue is that If I setup the file as only print on the Print Managerm, then i can get 7 up across the width of the media. But if i want to steup the file as a print & cut then i can only fit 6up acorss the media width. I tried different settings but could not make it happen and have been told that the cutter needs extra margin & so it is not possible. The current process leads to a lot of media wastage and just wanted to avoid that. Just wanted to know if someone else has faced a similar problem and is there any soultion. Any support on the matter will be appreciated.