Cancel search

Substrate Bow deformation

HP Latex 300 Series

#1 warrens6327 5 years ago

We have a HP Latex 335 printer and is giving us a 2.7mm deformation when printing on LG Hausys vinyl LD174G. I have entered the off set at -2,7mm in the subsrtate library, but when I cut it with my Mimaki cutter it still cuts incorrect. If I then put the opposite measurment in the RIP it then cuts correct sometimes?? Has anyone got any answers for us?

#2 warrens6327 5 years ago

As you can see the straightness optimization is set but the result is what you see? Very confusing or is the printer software working correctly?

Was this helpful?Yes0 No0
How can we improve it?
#3 HP-Sonia 5 years ago

Hello! Please check if the media is available on the HP Media Solution Locator and download the profile if available. You can adjust the temperature of the media, lower the ink density and add insterswarth delay, as well as, preheating the printer before starting. Besides, you should also ensure the media is properly stored and the environmental specs are followed.

If the issue continues you should request the media profile from the material vendor and contact their support.

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

New comments are not available at this time

Latest conversations HP Latex


HP Latex Blog


How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.