Intricate tiled print not lining up
Remember to document the settings you use during each test to help identify the most effective combination. The goal is to find a balance that minimizes stretching and misalignment for your specific printing setup and materials.
Yes0
No0
It will be helpful to record the parameters you use for each test so you can find the optimal combination. Finding the sweet spot where your printing setup and materials are most optimized for minimizing stretching and misalignment is the ultimate goal. basketball stars
Yes0
No0
Click to install Geometry Dash APK and dive into the world of rhythm-based platforming. Enjoy challenging levels, fast-paced action, and vibrant visuals, all while customizing your gameplay experience with exciting new features. Click here https://geometrydashpro.fun/
Yes0
No0
#1 said Hey Everyone, We are trying to print a VERY intricate (Aboriginal Artwork) tiled (2 tiles) print to Arlon DPF 4500, laminate and then mount them to ACM and the prints not lining up. We have tried turning the printer curing temperature down as low as possible (85°). We have laminated the prints on the lowest heat possible to avoid silvering and they still do not line up. It is almost 10mm of stretch on one of the tiles (see images attached) We are attempting to print them now with the output tension as low as possible and only printing 1 tile at a time, but we would love any advice on this issue. Thank you in advance Reply Yeah, we've run into this too with Arlon media it can stretch a fair bit, especially with heavy ink coverage or heat. Printing one tile at a time like you're doing is a good move. Also, try letting the prints rest for 24 hours before laminating to let them stabilize. Some people swear by using a take-up reel with minimal tension or even no take-up at all. And check if your RIP software has any shrink/stretch compensation settings. Hope it helps!
Yes0
No0
Hey Everyone, We are trying to print a VERY intricate (Aboriginal Artwork) tiled (2 tiles) print to Arlon DPF 4500, laminate and then mount them to ACM and the prints not lining up. We have tried turning the printer curing temperature down as low as possible (85°). We have laminated the prints on the lowest heat possible to avoid silvering and they still do not line up. It is almost 10mm of stretch on one of the tiles (see images attached) We are attempting to print them now with the output tension as low as possible and only printing 1 tile at a time, but we would love any advice on this issue. Thank you in advance