Cancel search

Output size compensation , am I doing it right?

#1 williamsandbrown6666 4 years ago

I seem to be struggling getting correct results using the output size compensation box.

This is how I do it..............

Open box, put in desired length/width in 'Test size' boxes, and next to it put results in 'measured size' boxes, the tick the 'enable output size compensation' box.

See screen grab. The length I required was 91.3cm, but it was coming out at 90.2. Those were the results

Thanks for your help


#2 HP-Sonia 4 years ago

Hello @williamsandbrown6666

The process is good, but I would suggest testing a bigger print.

Please see the official steps suggested by SAI:

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

New comments are not available at this time

Latest conversations HP Latex


HP Latex Blog


How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.