Cancel search

HP Latex - Image Swerving and Stepping off Path

#1 CyprusJack 2 months ago

Hi Guys, Hope you can help or offer some advice please

A couple of times today, and once during the week, we had the print almost swerve off its path Our prints have an equal gutter on each side of the print

The roll remains straight, it is not unwound uneven, but for some reason the print seems to be drifting off course

Almost in steps like a small swerve, before resuming a straighht line on a new path and then the same again

If you see the attached images

The result, was that what was a 2cm gutter on each side, had become almost 4cm on one side, and 0.5cm on the other side, after several metres of printing

Any suggestions what may be causing this ? Its only on one of our 5 machines Ive tried to show it in a diagram, and also a couple of shots that show how it swerves and drifts

Any help greatly appreciated

thanks a lot Jack

The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.