What was your overall satisfaction with LKC?
-
Very unsatisfied
-
1
-
2
-
3
-
4
-
5
-
Very satisfied
Good evening, I had to install the PLS firmware 40.22.52.1. I would like to understand if there is a way to deactivate the advance when I press the preheating before sending the print (attached photo). Honestly, the continuous movement of the material in the preparation phase is annoying and I would like to understand if there is a way to grab it at least in the preheating phase (when we type the thermometer icon). Is there a way to disable this advance... it's really frustrating and risky for the heads. Thank you Best regards