Dust sticks to wet latex imprint

Hello,

I have problem with my latex printer,

when i print imprints that needs more ink (like backlight foil 16p230%)

Some dust stick to the wet surface before drying chamber.

After printing when everything is dry you can remove this dust/powder but you have white spots (like ones from photos I attached)

Hello @Maciej

After looking at your images I can suggest to:

• Check the surface of the material? Try to keep the rolls in a clean, upright position and inside a bag.
• Check if there is dust in the place or above the printer, it could enter the printing area and cause the issue that you are explaining.

If you continue to experience the white spots in your prints. Let your support team look at it. From time to time you have to perform a service maintenance where different internal areas of the printer (curator, platen, etc.) are cleaned and some parts are replaced in case they need.