What was your overall satisfaction with LKC?
-
Very unsatisfied
-
1
-
2
-
3
-
4
-
5
-
Very satisfied
Hi,i added a new print mode recently and I have noticed the right hand edge of some prints (not all) seem to have a bit of extra bleed (correct me if i am wrong) before i was using an icc profile that fitted my media the closest 8p CMYKcm 90 curing temp 70(preset) and all prints well, since i added a new print mode and printed the colour saturation and ink drying test (not sure how to use this as of yet) with settings 6p CMYKcm 90 curing temp 60 i seem to have this problem, i have tried increasing the curing temp to 70 on the fly but made no difference. any help/suggestions appreciated. Regards.