Cancel search

Dual roll shafts

#1 gilman__st8708 3 years ago

Can I use the dual roll shaft with one width of substrate or is it best to only use them when printing dual roll jobs.

#2 dev.endonaldson4738710 3 years ago

Is your issue resloved? any recommendation how to solve this issue.? Can any one please help?

www.mygroundbiz.com

Was this helpful?Yes0 No0
How can we improve it?
#3 HP Daniela Ciolompea 3 years ago

Hi @gilman__st8708,

It is possible to use one with of substrate with the dual roll shaft, there are some recomendations when you use this configuration with one width of substrate:

• The minimum width of substrate should be 635 mm (25 in)

• You have to use the roll-to-roll configuration as it is the only configuration supported

• The roll should be loaded on the IPS side of the printer

• You shoud lock the differential in the middle of the spindle, using the lever on the left-hand side

Please find attached a document with the information found regarding this issue in the HP Latex 1500 User Guide.

Attachments
Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

New comments are not available at this time

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.