Cancel search

Firmware upgrade on new latex 115 print/cut

HP Latex Print and Cut Solutions

#1 Jadrewitz 6 years ago

I just setup the new 115 print cut and I’ve tried a number of times to update the firmware on the cutter without success. I’m am connected via Ethernet cable, downloaded the lasted firmaware and installed the HP Cutter Control. The display on the cutter shows it downloading and the freezes at 97% and after that tells me the upgrade failed. Upgrading from version 32 to 34. Any ideas?

#2 HP-Sonia 6 years ago

Hello @Jadrewitz

Please make sure you have the latest Firmaware installed: New Firmware for HP Latex 115 Printers

Was this helpful?Yes0 No0
How can we improve it?
#3 Jadrewitz 6 years ago

I was able to upgrade the FW using a USB cable but not over the network. Thanks

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

New comments are not available at this time

Latest conversations HP Latex


HP Latex Blog


How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.