HP Latex 54 Cutter

When I go to cut I load the substrate into the cutter, press the bar code button, position the sensor and hit the play button. It start doing its thing reading the bar code, goes from lower right corner up to upper right corner then over to upper left corner like always then circles around, stops, beeps, and says "SET TOOL ABOVE MARK", what does that mean?

Attachments

   IMG_3537.jpg

   IMG_3538.jpg

Hi. What types of substrates can the hp latex 54 basic cutter cut?

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel

#3 Hi @enriquesousa.sccp7246, It depends on thickness media and cut you want to use. For the hp latex 54 datasheet, you can find media's specs here: http://h20195.www2.hp.com/v2/getpdf.aspx/4AA7-1558ENE.pdf

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel