latex 330

Guys does anybody know hoe to fix this issue? thanks

#1 Hi @charbelchaaya5230,

My first recommendation would be to try to perform a printhead cleaning routine but if the issue persists probably you should replace the printheads. Another "good practice" is to check if the maintenance cartridge is good conditions.

Please, let me know if this helps, Warm regards,

#2 Hi tx dear for your reply actually i switched the position of the magenta yelow print heads now the yellow have the gradients solid colors does not have a problem!!! what is it do you think attached for reference thanks again

Hello Guys I replaced new printheads and done several alignments but still i have this gradiants issue for solid colors, Anyone suggest what to do? Attached for ref.

#4 After seeing the image. I would recommend replacing PrintHeads and maintenance cartridge, but as you said it was already done. I would call a service engineer to have a better understanding of the issue.

#4 Hi charbelchaaya5230, problems are with not good contact of printheads in the carriage. You must clean very good the printheads contacts and the little gold dots on the strips where printheads are sitting. When we first installed printheads, half of them were like first picture posted by you - there LM/LC printhead is Offline . About the condition of printheads - try to print from Settings -> Image quality -> Clean printheads -> Print test plot...