Cancel search

HP Cutter 54: Pause, remove substrate, put substrate back, resume

#1 bhprinter 3 months ago

Might be a dumb question, but I've spent hours trying to look for a specific answer with no avail..

I make stickers and more often than not, the stickers require a transfer sheet over it. Is there a way where I could

  1. have the cutter do a kiss cut and pause before the next cut (I know this part is possible)..
  2. and then I REMOVE the substrate to apply a transfer sheet over the stickers
  3. then place the substrate with transfer sheet applied and RESUME the cutting again with the next cutting color, such as a perf cut, but using the same OPOS barcode and alignment?

Any information would be extremely appreciated. Thank you!

#2 HP Daniela Ciolompea 2 months ago

Hi @bhprinter,

Please find below the answer we have received from Summa:

It is not possible to configure the cutter to do kiss cutting and ignore perf cutting, or ignore kiss cutting and do the perf cutting.

However, you can tell the software that has to do the kiss cutting or the perf cutting after it has read the barcode.

This is something that should be possible using GoSign, as in this software different layers (or colors) can be set as active or inactive.

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.