Cancel search

Contour Cutting 5 layer sandwich mode on HHP Latex 700W

#1 Digimike 2 years ago

So this mode is terrific for the small label guys And I know SAI Flexi RIP had a procedure for cutting 3 layer. Is anyone up to speed with cutting 5 layer work yet.

#2 Digimike 2 years ago

#1 HELLO

Was this helpful?Yes0 No0
How can we improve it?
#3 HP Daniela Ciolompea 2 years ago

Hi @Digimike,

It is possible with SAI (it is better to use the latest build). The procedure is the same as in 3 layers. The contour cut should be in only 1 image. I hope this helps.

Was this helpful?Yes0 No0
How can we improve it?
#4 Digimike 2 years ago

#3 No success yet any updates or white papers to read

Was this helpful?Yes0 No0
How can we improve it?
#5 HP Daniela Ciolompea 2 years ago

Hi @Digimike,

I suggest one of these 2 options: either contact your support representative, or Flexi directly. Apologies that I am not able to help further on this matter.

Was this helpful?Yes0 No0
How can we improve it?
#6 Digimike 2 years ago

#5 Neither are they

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

New comments are not available at this time

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.