Cancel search

latex cutter help

#1 adeptproducts10308 6 days ago

I have the design printed and loaded in cutter. The cutter reads both bar codes and all the registration marks. It goes thru the animation of the cut but afterwards when it ends it says OPOS Cannot detect XY correction line. What am i doing Wrong?

#2 HP Daniela Ciolompea 4 days ago

Hi @adeptproducts10308,

When using the OPOS-XY mode there could be an excessive bowing of the contour being introduced. This is because the horizontal line used to compensate for the bowing effect was not read correctly by the OPOS sensor. This could be due to the following:

The sensitivity of the OPOS sensor was not set to match the media used.

Click Menu > Calibrations > Calibrate media (OPOS) > Set to check current setting, or run the OPOS sensor sensitivity test: click Menu > Calibrations > Calibrate media (OPOS) > Measure.

Was this helpful?Yes0 No0
How can we improve it?
#3 adeptproducts10308 4 days ago

#2 said

Hi @adeptproducts10308, When using the OPOS-XY mode there could be an excessive bowing of the contour being introduced. This is because the horizontal line used to compensate for the bowing effect was not read correctly by the OPOS sensor. This could be due to the following: The sensitivity of the OPOS sensor was not set to match the media used. Click Menu > Calibrations > Calibrate media (OPOS) > Set to check current setting, or run the OPOS sensor sensitivity test: click Menu > Calibrations > Calibrate media (OPOS) > Measure.

thank you

Was this helpful?Yes0 No0
How can we improve it?
#4 mohammad Ashour 2 days ago

I have one paper is Oracal Perforerad PL6750 Do you know which file i can use to my machine HP Latex 570 Mohammad Ashour

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Latex Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.